nsdiag
nsread nsconf nsloop nswait nsuart nshex NSZ Files Download Interface Library Source Code SDKnsdiag - NSDSP-3 Diagnostic Utility
NSDSP-3 monitors various voltages. If it detects overvoltage condition or overload, it turns off everything it can and enters error mode. Both red and green lights turn on, end stops responding to commands. This is a safety feature.
Red and green lights also turn on when you edit the programmer settings, to let you adjust the brightness. This does not constitute the error mode.
If you see both red and green lights on, we suggest disconnecting the programmer from the circuit and run nsdiag. It will print the cause which triggered the error mode. You should correct the erroneous condition, then run nsdiag again with -r option to return the programmer into the working state.
nsdiag does not work with NSDSP-1 or NSDSP-2.
You can use the following parameters
| Parameter | Description |
|---|---|
| -s serial | Specifies the serial number of the NSDSP chip. This lets you select a particular NSDSP when several ones are connected. This parameter is optional. If not specified, NSDSP will be selected randomly. You can use nsenum to display the list of serial numbers of the NSDSPs connected to the computer. |
| -r | Instructs nsdiag to re-enumerate and reset the programmer. If an error condition has been detected this will restore the function of the programmer. |
© 2007-2026 Northern Software Inc. All Rights Reserved.