PIC32MK0512MCJ048

Support summary

• Programming - Yes
• Debugging provisions - Yes

ICSP Connection

PIC32MK0512MCJ048 has more than one pair of PGECx and PGEDx pins. You can use any pair, but you must use them as a pair. For example, if PGEC2 is used for ICSPCLK, then ICSPDAT must be connected to PGED2.

All VSS and VDD pins must be connected. Even if one of these pins is not connected, programming may fail.

TDO pin will toggle at high frequency during programming. Make sure this does not harm your circuit.

Programming Benchmarks for NSDSP-1 and NSDSP-2

We have measured time necessary to program and verify PIC32MK0512MCJ048 with NSDSP-1 or NSDSP-2 (both yeild the same speed).

Operation	Time
Programming and Verification	11.3s
Programming only	10.0s
Verification only	8.9s

The measurements reflect the time necessary to program/verify the entire chip, including all user programmable memory areas.

Debugging

NSDSP firmware contains all the necessary provisions for debugging PIC32MK0512MCJ048 and may be debugged when debugging software becomes available.

PIC32MK0512MCJ048 uses ordered halting, has 10 hardware breakpoints.

Debugger requires 896 bytes of ROM and 20 bytes of RAM.

TDO pin does not work during debugging.

Links

Microchip PIC32MK0512MCJ048 page