PIC16F886PIC16F887 PIC16F913 PIC16F914 PIC16F916 PIC16F917 PIC16F946
All VSS and VDD pins must be connected. Even if one of these pins is not connected, programming may fail.
Since NSDSP is a Low-Voltage Programmer (LVP), it can only program PIC devices if LVP configuration bit is enabled. Fresh (unprogrammed) devices have LVP bit set and therefore they can be programmed. It is impossible to disable LVP bit during LVP programming, but if the device has been previously programmed with HVP programmer, the LVP bit may have been disabled.
When brown-out is enabled with BOREN configuration bit, LVP is only possible when the VDD voltage is above the brown-out threshold.
Target Voltage Below 4.5V
If voltage is less than 4.5V programming is severely limited - it is impossible to bulk erase the device, it is also impossible to erase configuration bits, EEPROM, UID.
NSDSP cannot detect target voltage and it assumes that the voltage is above 4.5V. If the actual target voltage is less, programming will fail. However, if you tell NSDSP that the target voltage is below 4.5V through programming software, NSDSP will use special low-voltage programming mode. In this mode, NSDSP verifies if the desired programming can be performed at voltages below 4.5V, and if it is possible (device is not code protected, configuration bits do not change or only change from 1 to 0, EEPROM is not programmed, UID is not programmed), it performs the programming. If such programming is impossible, NSDSP software will stop and show an error message.
Programming in low-voltage mode may be considerably slower. In addition, you may need to decrease programming speed to 3MHz or below.
PIC16F886 does not have built-in debugging capabilities and cannot be debugged.
© 2007-2020 Northern Software Inc. All Rights Reserved.