PIC16F627APIC16F628 PIC16F628A PIC16F630 PIC16F631 PIC16F636 PIC16F639 PIC16F648A PIC16F676 PIC16F677 PIC16F684 PIC16F685 PIC16F687 PIC16F688 PIC16F689 PIC16F690 PIC16F707 PIC16F716 PIC16F720 PIC16F721 PIC16F722 PIC16F722A PIC16F723 PIC16F723A PIC16F724 PIC16F726 PIC16F727 PIC16F753 PIC16F785 PIC16F818 PIC16F819 PIC16F84A PIC16F87 PIC16F870 PIC16F871 PIC16F872 PIC16F873 PIC16F873A PIC16F874 PIC16F874A PIC16F876 PIC16F876A PIC16F877 PIC16F877A PIC16F88 PIC16F882 PIC16F883 PIC16F884 PIC16F886 PIC16F887 PIC16F913 PIC16F914 PIC16F916 PIC16F917 PIC16F946
Programming is impossible at voltages below 4.5V.
Low-Voltage Programming (LVP) can only be used for these PIC devices if the LVP configuration bit is enabled. Fresh (unprogrammed) devices have LVP bit set and therefore they can be programmed. It is impossible to disable LVP bit during LVP programming, but if the device has been previously programmed with HVP programmer, the LVP bit may have been disabled.
When brown-out is enabled with BOREN configuration bit, LVP is only possible when the VDD voltage is above the brown-out threshold.
These limitations may be avoided with High-Voltage Programming (HVP). NSDSP-2 can generate high voltage for HVP internally. NSDSP-1 cannot, therefore NSDSP-1 requires an external circuit for HVP.
NSDSP-2 can generate 12 V voltage internally, and therefore can programPIC16F627A with HVP.
With NSDSP-1, HVP programming is possible, but only with an external HVP circuit.
NSHVX will not work with PIC16F627A because NSHVX produces 9 V high voltage, but this chip requires at least 11 V. If you need NSHVX version which produces 12 V and is suitable for this PIC, please contact us.
Microchip HVP programming specificatons for PIC16F627A require that VPP is applied to MCLR before VDD. Since NSDSP does not have any control of VDD, this requirement cannot be satisfied, however, in our tests the HVP programming has succeeded even without VDD manipulation. Therefore, NSDSP software, starting release 126, supports HVP programming for PIC16F627A.
Be careful. It is possible to brick PIC16F627A with HVP programming if each of these three conditions is met:
NSDSP cannot be used to debug PIC16F627A.
© 2007-2023 Northern Software Inc. All Rights Reserved.