Cart Contact NSDSP Home

PIC32MM0064GPL020

ICSP connection

Support summary

  • Programming - Yes
  • Debugging provisions - Yes

ICSP Connection

PIC32MM0064GPL020 has more than one pair of PGECx and PGEDx pins. You can use any pair, but you must use them as a pair. For example, if PGEC2 is used for ICSPCLK, then ICSPDAT must be connected to PGED2.

Programming JTAGEN=OFF

NSDSP requires at least 500kHz speed to program the JTAGEN configuration bit on this device to OFF (0). If you use slower speed, the JTAGEN bit will remain ON (1) and verification will fail. Since NSDSP typically uses much faster speed for programming this doesn't usually pose a problem.

Debugging

NSDSP firmware contains all the necessary provisions for debugging PIC32MM0064GPL020 and may be debugged when debugging software becomes available.

PIC32MM0064GPL020 uses ordered halting, has 6 hardware breakpoints.

Debugger requires 768 bytes of ROM and 20 bytes of RAM.

Links

Microchip PIC32MM0064GPL020 page

Northern Software Home NSDSP Contact Us Purchase/View Cart

© 2007-2025 Northern Software Inc. All Rights Reserved.