PIC32MM0016GPL036PIC32MM0032GPL020 PIC32MM0032GPL028 PIC32MM0032GPL036 PIC32MM0064GPL020 PIC32MM0064GPL028 PIC32MM0064GPL036 PIC32MM0064GPM028 PIC32MM0064GPM036 PIC32MM0064GPM048 PIC32MM0064GPM064 PIC32MM0128GPM028 PIC32MM0128GPM036 PIC32MM0128GPM048 PIC32MM0128GPM064 PIC32MM0256GPM028 PIC32MM0256GPM036 PIC32MM0256GPM048 PIC32MM0256GPM064
PIC32MM0016GPL036 has more than one pair of PGECx and PGEDx pins. You can use any pair, but you must use them as a pair. For example, if PGEC2 is used for ICSPCLK, then ICSPDAT must be connected to PGED2.
All VSS and VDD pins must be connected. Even if one of these pins is not connected, programming may fail.
NSDSP requires at least 500kHz speed to program the JTAGEN configuration bit on this device to OFF (0). If you use slower speed, the JTAGEN bit will remain ON (1) and verification will fail. Since NSDSP typically uses much faster speed for programming this doesn't usually pose a problem.
NSDSP firmware contains all the necessary provisions for debugging PIC32MM0016GPL036 and may be debugged when debugging software becomes available.
© 2007-2018 Northern Software Inc. All Rights Reserved.