Buy(Cart) Contact NSDSP Home

PIC32MM0064GPL036

Support summary

  • Programming - Yes
  • Debugging provisions - Yes
ICSP connection

 

ICSP Connection

PIC32MM0064GPL036 has more than one pair of PGECx and PGEDx pins. You can use any pair, but you must use them as a pair. For example, if PGEC2 is used for ICSPCLK, then ICSPDAT must be connected to PGED2.

All VSS and VDD pins must be connected. Even if one of these pins is not connected, programming may fail.

 

Programming JTAGEN=OFF

NSDSP requires at least 500kHz speed to program the JTAGEN configuration bit on this device to OFF (0). If you use slower speed, the JTAGEN bit will remain ON (1) and verification will fail. Since NSDSP typically uses much faster speed for programming this doesn't usually pose a problem.

 

Debugging

NSDSP firmware contains all the necessary provisions for debugging PIC32MM0064GPL036 and may be debugged when debugging software becomes available.

 

Links

Microchip PIC32MM0064GPL036 page

Northern Software Home NSDSP Contact Us Purchase/Vew Cart

© 2007-2018 Northern Software Inc. All Rights Reserved.